1 Topic by Kin3zu

  • Kin3zu
  • Newbie
  • Offline
  • Registered: 2017-09-01
  • Posts: 1

Topic: Layer alignment. Cannot figure out.

http://soliforum.com/i/?o558J91.jpg
Hi, i build an corexy 3d printer, with belt driven z axis and it seams that every print has some misalignment layers. Ilowerd the print sleed but it seams the problem persist.

Post's attachments

Gear pict.jpg
Gear pict.jpg 998.88 kb, file has never been downloaded. 

You don't have the permssions to download the attachments of this post.

2 Reply by Teamfox201

  • Teamfox201
  • Newbie
  • Offline
  • Registered: 2015-12-07
  • Posts: 2

Re: Layer alignment. Cannot figure out.

I know it’s an old post but check out the link below for some troubleshooting steps.

https://www.simplify3d.com/support/prin … e-of-print