1 Topic by kielmcgettigan

  • kielmcgettigan
  • Newbie
  • Offline
  • Registered: 2017-04-05
  • Posts: 3

Topic: da Vinci Mini w with cura

I'm trying to find a way to use cura to print without having to then load it into the XYZ.  I have seen the XYZware open mod but all the links are dead.  Is there a new way to connect it with out flashing that I won't have to edit the gcode file manually?

2 Reply by jjveldscholten

  • jjveldscholten
  • Member
  • Offline
  • Registered: 2017-02-17
  • Posts: 16

Re: da Vinci Mini w with cura

First you have to convert the printer to a ramps 1.4 Board, there are tutorials on the forum.

3 Reply by kielmcgettigan

  • kielmcgettigan
  • Newbie
  • Offline
  • Registered: 2017-04-05
  • Posts: 3

Re: da Vinci Mini w with cura

So there is no software solution only a mod solutions at this time.

4 Reply by jjveldscholten

  • jjveldscholten
  • Member
  • Offline
  • Registered: 2017-02-17
  • Posts: 16

Re: da Vinci Mini w with cura

kielmcgettigan wrote:

So there is no software solution only a mod solutions at this time.

Correct, because the XYZ software is putting out a Gcode with a encryption or something.