1 Topic by asarm057

  • asarm057
  • Newbie
  • Offline
  • Registered: 2016-06-25
  • Posts: 7

Topic: Fried 1.0A Board

Hello!

I recently discovered that while installing the E3D V6 Hot end I did a poor soldering job and fried the 12v supply to the rest of the board, such as my heating element which isn't allowing my extruder to heat up as well as lack of an LCD screen.

I was wondering if there is a way to get a replacement 1.0A board/ does anyone have a non-functional Da Vinci 1.0A that they can spare a board?

2 Reply by carl_m1968

  • carl_m1968
  • carl_m1968
  • Member
  • Offline
  • From: Far North almost not Dallas
  • Registered: 2014-10-17
  • Posts: 6,512

Re: Fried 1.0A Board

The board is easy to repair. It is just a blown zero ohm resistor they use as a fuse near the 12 volt input terminal.

Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.

3 Reply by evanalmighty

  • evanalmighty
  • Member
  • Offline
  • Registered: 2015-01-04
  • Posts: 224

Re: Fried 1.0A Board

I think I have a spare board if you're interested