1 Topic by neonorangehats

  • neonorangehats
  • Newbie
  • Offline
  • Registered: 2016-03-07
  • Posts: 5

Topic: Davinci 2.0A raft/brim with 2nd extruder not working (stock firmware)

In XYZware print settings I want to print a part with extruder 1 and I want the brim or raft to be in a different colour using extruder 2. However, when the object slices it wants to print everything (including the brim or raft) with extruder 1. Completely ignoring my extruder 2 setting.

Note: Supports with extruder 2 work perfectly fine.

Is there an extra button or setting I'm missing? What's going on?

2 Reply by mark.burton

  • mark.burton
  • Member
  • Offline
  • From: United states
  • Registered: 2015-05-28
  • Posts: 336

Re: Davinci 2.0A raft/brim with 2nd extruder not working (stock firmware)

Why did you make 3 posts of the same thing?

3 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: Davinci 2.0A raft/brim with 2nd extruder not working (stock firmware)

Probably just wanted to make sure I had something to do wink
OP I deleted your other 2 identical posts.

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website