sd2 in need of upgrade!!! (Page 2 of 2)

Yes Its was

Yes!! that worked for the Y axis. I was able to fine the sweet "spot" Thank you thank you. It didnt work for the Z or X though No matter where I turn the pot they just sit there not making a sound. Now if I plug the X or Z motor into the Y port on the board im able to jog them just fine.

Ok I will try this tomorrow Ive got to leave now Thank You so much for all yalls help.

Now take that one working driver out and plug it into one of the non working axis and see if that axis will now move.  Repeat for all.  This will tell us if the board is functional or not.

Well, yeah you're going to have some adjustment needed.  This tells us that your drivers are either failing or simply overheating.  I'd recommend replacing the drivers instead of the whole board.  Go to MakerFarm and buy some Good replacements.  Alternately you could upgrade to a Rumba board or an Azteeg X3.  There's plenty of Ramps 1.4 boards out there but as of right now I can't recommend one of those, too many cheap ones out there that don't work properly.

Yep

That driver on E:, must be a geetech DRV8825?  That would be correct if that's the case.  If you are looking to verify, each pin is labeled on the board and driver, just match them up.  The silkscreen on the drivers is on the under side of the board.

All you can do is turn up the VREF on that driver until it starts turning.  make sure the s endstop isn't triggered and that you are telling it to move down (up arrow) in RH.  assuming all else is good you may have a bad driver.

Since you've verified the motor works this leaves only board failure or something seriously incorrect with your firmware settings.  Both being very solvable problems.

That leaves you with a Ramps 1.4 but I bet someone here on the forum has a used Sang or PrintrBoard they're willing to sell.  Maybe do a post in the B/S/T section and see what you can come up with.