1 Topic by Denial84 (edited by Denial84 2016-02-05 13:10:55)

  • Denial84
  • Newbie
  • Offline
  • Registered: 2014-07-09
  • Posts: 1

Topic: Replacing Print Glass to MK2

Goodmorning everyone! Unfortunately printing glass is breaking ... for the second time already replaced one year ago!

Since I can not dependent on assistance for life. I want to install the bed MK2 but I read that the thermistor is a 500k  can confirm? Some of you did this change?
TNx!!!

Post's attachments

print_bed_thermistor_graph.png
print_bed_thermistor_graph.png 9.46 kb, file has never been downloaded. 

You don't have the permssions to download the attachments of this post.

2 Reply by kev0175

  • kev0175
  • Member
  • Offline
  • Registered: 2015-02-17
  • Posts: 146

Re: Replacing Print Glass to MK2

If you have a 1.0 or 2.0 you can buy a glass and heater from Davincizone

Da Vinci  AiO with firmware 1.1.1 using xyzscan 1.1.18
E3Dv6 hotend with custom carriage with Borosilicate glass bed
123D Design and Simplify3D, Replaced PS with a Solidgear Flex320
Zerokart resetter,  Installed a Extruder Controller for higher temps