1 Topic by Farouq11

  • Farouq11
  • Newbie
  • Offline
  • Registered: 2016-01-12
  • Posts: 7

Topic: How to add an extra fan?

Hi, I've had my Da Vinci 1.0 for a month now and I think I've finally got it to print PLA without jamming by adding a fan shroud. My prints aren't too good, but I've heard from others that adding an extra fan would make the prints better. I bought a 12V fan but I don't know where to mount it, where would yall mount it and how? Thank you.

2 Reply by kev0175

  • kev0175
  • Member
  • Offline
  • Registered: 2015-02-17
  • Posts: 146

Re: How to add an extra fan?

I believe there are a few fan shrouds on Thingiverse

Da Vinci  AiO with firmware 1.1.1 using xyzscan 1.1.18
E3Dv6 hotend with custom carriage with Borosilicate glass bed
123D Design and Simplify3D, Replaced PS with a Solidgear Flex320
Zerokart resetter,  Installed a Extruder Controller for higher temps

3 Reply by scobo

  • scobo
  • scobo
  • Member
  • Offline
  • From: Scotland - UK
  • Registered: 2014-08-09
  • Posts: 993

Re: How to add an extra fan?

50mm fan- http://www.thingiverse.com/thing:447903

40mm fan - http://www.soliforum.com/topic/13385/ho … extra-fan/

Davinci 1.0 with repetier firmware & E3D V6 Lite
Anycubic Photon DLP printer, Einscan-S 3D scanner
Simplify3d, 123D Design, Meshmixer
http://www.thingiverse.com/scobo/designs

4 Reply by TheNeck

  • TheNeck
  • TheNeck
  • Member
  • Offline
  • Registered: 2014-05-25
  • Posts: 77

Re: How to add an extra fan?

for me this 50mm fan duct works great as well

https://www.thingiverse.com/thing:641370

5 Reply by Farouq11

  • Farouq11
  • Newbie
  • Offline
  • Registered: 2016-01-12
  • Posts: 7

Re: How to add an extra fan?

Thank you!