1 Topic by GeauxGhoti

  • GeauxGhoti
  • Newbie
  • Offline
  • Registered: 2015-12-13
  • Posts: 9

Topic: Bottom layers a bit... off

Can anyone tell me what's going on with the bottom few layers?

This was printed on a Da Vinci AiO from ABS with 90% infill and 0.2mm layer height, at "Excellent" quality and "Auto Repair" checked (if that makes any difference...)

http://soliforum.com/i/?Emss4IL.jpg

2 Reply by e.morgan93

  • e.morgan93
  • Newbie
  • Offline
  • Registered: 2016-02-27
  • Posts: 5

Re: Bottom layers a bit... off

Did the prints curl up at all? This sometimes happens if it curls up and the hotend catches on it and moves the axis a little