1 Topic by SigmaTech

  • SigmaTech
  • Newbie
  • Offline
  • Registered: 2016-01-03
  • Posts: 3

Topic: Fix for: DaVinci 1.0 error 0014 (Extruder temp stuck at 10C)

So I spend hours in despair probing my new 3D printer with a multimeter since it displayed an "Error 0014"

But I'm so happy because
I found out how to fix it

Here's how to troubleshoot it:

  • Check connectors on extruder

  • Open back panel. Check connectors on the motherboard.

  • Check thermistor resistance for responsiveness with a multimeter. Room temp should be 100k ohms.
    Refer to this chart to check the temp based on resistance: http://www.bapihvac.com/content/uploads … r_100K.pdf

In my case there was just a loose connector at the back panel where the motherboard is. I was reluctant to open it thinking it would void my warranty. But I'm so happy I did open that panel! Connector was probably dislodged during shipping. http://soliforum.com/i/?H1Kd4Fe.jpg

This saved me so much time and money. And when I fixed it I was jumping and screaming.
So proud to do this at 16 years old. smile

Printer: Da Vinci 1.0
Modeling Software: ROBLOX
Slicing Software: 3DBuilder (Windows 10)

SigmaTech's Website

2 Reply by scobo

  • scobo
  • scobo
  • Member
  • Offline
  • From: Scotland - UK
  • Registered: 2014-08-09
  • Posts: 993

Re: Fix for: DaVinci 1.0 error 0014 (Extruder temp stuck at 10C)

Well done !
Had a similar problem recently but in my case, the yellow thermistor wire had been badly damaged after a short. I got low temps and the def error.
Had to replace the wire all the way to the main board but all is well now.

Davinci 1.0 with repetier firmware & E3D V6 Lite
Anycubic Photon DLP printer, Einscan-S 3D scanner
Simplify3d, 123D Design, Meshmixer
http://www.thingiverse.com/scobo/designs