Topic: Error 33? Z axis won't stop
Just started happening. After the job is received the print bed starts moving up, but will go until it's rammed into the top, and then I get my error.
Haven't a clue where to begin.
- carl_m1968
- Member
- Offline
Re: Error 33? Z axis won't stop
Your Z sensor the white plastic assembly at the back of the printer above the bed is either not positioned correctly, wires are disconnected or on backwards or the sensor in the assembly is bad. To test the sensor you could swap it for the X sensor in the housing on the right side of the carriage or the door sensor in the upper back right portion of the lid channel. Otherwise make sure the wires are secure and plugged in the same as the other sensors.
Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.
Re: Error 33? Z axis won't stop
What can you do if the sensor itself is bad?
- carl_m1968
- Member
- Offline
Re: Error 33? Z axis won't stop
wordoftheday wrote:
What can you do if the sensor itself is bad?
There are several here that are parting out their Da Vinci's. Ask around as someone may have some sensors available. You could try XYZ but lots of luck, Seems they where planning to have everyone ship the entire printer back for repairs and never anticipated people willing to do their own repairs thus making parts available.
Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.