1 Topic by selkess

  • selkess
  • Member
  • Offline
  • Registered: 2014-08-12
  • Posts: 134

Topic: Lincomatic's BootloaderHID

Im reading on this site http://wiki.solidoodle.com/update-firmware
on how to update press firmware..

is it possible to update using the guide whit  Lincomatic's BootloaderHID in cmd
and just jumper the board into bootmode whit the same usb cable to my pc ?

or is the only way of updating using a arduino board of some kind?
no one seems to tell right or wrong here.

2 Reply by Codum

  • Codum
  • Codum
  • Member
  • Offline
  • From: West Coast
  • Registered: 2015-01-17
  • Posts: 38

Re: Lincomatic's BootloaderHID

Selkess, I'd love to hear on this subject too. Can't we assume that Solidoodle updated the firmware on later deliveries since the date on the that firmware version is March (2 months after initial deliveries).

Solidoodle Press
SolidWorks 2014

3 Reply by selkess

  • selkess
  • Member
  • Offline
  • Registered: 2014-08-12
  • Posts: 134

Re: Lincomatic's BootloaderHID

Codum wrote:

Selkess, I'd love to hear on this subject too. Can't we assume that Solidoodle updated the firmware on later deliveries since the date on the that firmware version is March (2 months after initial deliveries).


i did the update flashing whit bootloaderhid and works fine  but need recalibrate everything again after

4 Reply by knowack

  • knowack
  • Member
  • Offline
  • From: Columbia, MO
  • Registered: 2013-12-05
  • Posts: 612

Re: Lincomatic's BootloaderHID

I've updated the firmware on my SD4 a couple of times.  The arduino board they refer to is the printer motherboard.  You just plug your printer into your computer like normal.  I've always closed R-H while doing the update, I just assumed it would conflict with the process.

5 Reply by selkess

  • selkess
  • Member
  • Offline
  • Registered: 2014-08-12
  • Posts: 134

Re: Lincomatic's BootloaderHID

knowack wrote:

I've updated the firmware on my SD4 a couple of times.  The arduino board they refer to is the printer motherboard.  You just plug your printer into your computer like normal.  I've always closed R-H while doing the update, I just assumed it would conflict with the process.


yes it works flawless  now i need to learn how to edit the firmware also..