1 Topic by trimvein

  • trimvein
  • Newbie
  • Offline
  • Registered: 2015-06-26
  • Posts: 3

Topic: Calibration Error - +ERR, +ERR, +ERR

Hello, I have been having calibration error pretty often.  I was able to print with this error but now it's so bad the printer won't push out the filament.  I don't know if this is because of the printer calibration or some other error. 

When I do try a calibration I get the +ERR,+ERR,+ERR.  It stays in the back right corner and evaluates only 1 point 3 times and then give me the image I attached with three errors. 

Has anyone had this issue?  I read several forums and yet to have found a solution.  I tried the XYZ printing calibration tutorials, and I found another attempt and manual calibration on a test print.  I will try that asap.  However, if anyone else has any feedback I would be greatly appreciate the help:)

Attached video of how my Davinci calibration is stuck and the error message... sad F$(^

Thanks
JT

Post's attachments

20150622_095849.jpg
20150622_095849.jpg 982.49 kb, file has never been downloaded. 

You don't have the permssions to download the attachments of this post.

2 Reply by efes

  • efes
  • Member
  • Offline
  • From: Belgium
  • Registered: 2015-06-13
  • Posts: 110

Re: Calibration Error - +ERR, +ERR, +ERR

If the value shown is always ERR,ERR,ERR, follow the steps below to clean.
¡ Reminder
CALIBRATE
fail
ERR,ERR,ERR
[OK] TO RETURN
A. Clean the surface of the print head
using the copper brush.
(Clean the contact point between the print
head and print bed)
B. Wipe and clean the measurement
points as shown in step 4.
C. Perform the calibration process again.

davinci 1.0
firmware repetier

3 Reply by trimvein

  • trimvein
  • Newbie
  • Offline
  • Registered: 2015-06-26
  • Posts: 3

Re: Calibration Error - +ERR, +ERR, +ERR

I guess the video didn't upload....

I can send via dropbox if anyone can help

thanks

4 Reply by trimvein

  • trimvein
  • Newbie
  • Offline
  • Registered: 2015-06-26
  • Posts: 3

Re: Calibration Error - +ERR, +ERR, +ERR

Thanks efes i will try that

5 Reply by nickgarrett09

  • nickgarrett09
  • Newbie
  • Offline
  • Registered: 2015-06-23
  • Posts: 4

Re: Calibration Error - +ERR, +ERR, +ERR

Yup, clean clean clean. That should help!