1 Topic by Limitless

  • Limitless
  • Newbie
  • Offline
  • Registered: 2014-09-15
  • Posts: 4

Topic: 3DPrinterOS Software

Hey fellow print-enthusiasts.

I've been using www.3DPrinterOS.com now for a month. The reason i'm writing this post now, after a month of "test period" is simple. It is super exciting and easy to use. Connecting your printer to the cloud takes only a few minutes and after that the software itself takes care basically of everything. Printers I've used with that OS are Ultimaker 2 and Rapide Lite 200 and they've worked flawlessly while using 3dprinteros.  It's an all-in-one platform and it has been out only since March thus not much content has been around about it.

2 Reply by justsomeguy

  • justsomeguy
  • Member
  • Offline
  • Registered: 2012-10-31
  • Posts: 302

Re: 3DPrinterOS Software

Using cloud software gets you rained on sooner or later. 

Own your software or you'll get owned.

3 Reply by heartless

  • heartless
  • heartless
  • Member
  • Offline
  • From: Northcentral Wisconsin
  • Registered: 2015-04-08
  • Posts: 2,152

Re: 3DPrinterOS Software

i am not a big fan of cloud based stuff, either... out here in the boonies, it is common to have internet outages - internet goes down, print ruined... and that would suck when you are well into a multi-hour print.

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1