1 Topic by fran.cuesta.marin (edited by fran.cuesta.marin 2015-03-24 02:45:30)

  • fran.cuesta.marin
  • Member
  • Offline
  • From: California
  • Registered: 2015-03-23
  • Posts: 14

Topic: Hi, Nice to meet Y'all!

Im new here, and im planning to buy a Solidoodle 4/Solidoodle Workbench Apprentice , as  my main printer, and im also planning to use it with its full potential, so im going to buy the E3D HotEnd and a Bulldog XL Extruder, but since i dont have the printer right now, and i have never used a SD printer before, so im not sure if it will work. So im asking for advice here.
Thanks in advance

2 Reply by ysb (edited by ysb 2015-03-24 17:38:45)

  • ysb
  • ysb
  • Member
  • Offline
  • From: quebec, canada
  • Registered: 2012-08-09
  • Posts: 1,164

Re: Hi, Nice to meet Y'all!

welcome,
forget this SPAM, and you'd better go to the section "solidoodle discussion" for better advice or "3D Printer Discussion" for generic advice..


fran.cuesta.marin wrote:

Im new here, and im planning to buy a Solidoodle 4/Solidoodle Workbench Apprentice , as  my main printer, and im also planning to use it with its full potential, so im going to buy the E3D HotEnd and a Bulldog XL Extruder, but since i dont have the printer right now, and i have never used a SD printer before, so im not sure if it will work. So im asking for advice here.
Thanks in advance

Find all my 3D printable models here
Game of ropes 2 online..Adult only

ysb's Website