Topic: solidoodle workbench apprentice calibration
i have been working on this printer for a few weeks now and i am still yet to run a print. whenever the printer starts its auto calibration it goes through all the probing and when it pushes up the probe it doesn't push it up far enough so the extruders are still about 1mm off the print bed. also when the x and y go to the back right corner, the probe isn't far enough up so it gets caught when the extruders move to the middle of the bed to run the print, the probe gets caught on the edge of the bed because the bed is up to far. please help i am only a high school student and simply am not to far into learning coding but I'm always working on the printers. and i have tried everything that i have learned so far from reading these forums but still can't get anything with the auto calibration to work.
