1 Topic by ottoangel (edited by ottoangel 2015-02-25 00:05:04)

  • ottoangel
  • Member
  • Offline
  • Registered: 2015-01-29
  • Posts: 29

Topic: Axis off after nasty sound

Approximately 25 minutes in my Raspberry Pi enclosure print I heard a unpleasant sound. After that the axis seem to be off. Please see attached picture.

Post's attachments

IMG_20150225_005446.jpg
IMG_20150225_005446.jpg 2.23 mb, 2 downloads since 2015-02-25 

You don't have the permssions to download the attachments of this post.

2 Reply by Robny

  • Robny
  • Member
  • Offline
  • Registered: 2014-08-25
  • Posts: 89

Re: Axis off after nasty sound

Did the wire bundle get caught at the back, or did the filament get stuck and tug on the extruder?

3 Reply by ottoangel

  • ottoangel
  • Member
  • Offline
  • Registered: 2015-01-29
  • Posts: 29

Re: Axis off after nasty sound

I have secured the wire bundle so I don't think that is the problem. Neither did the filament get stuck. The printer has made this sound once before when calibrating. Then it was in the front left position I think. It seems like something happened and then suddenly it lost track of where it was before.