1 Topic by pbcrazy

  • pbcrazy
  • Member
  • Offline
  • Registered: 2015-01-05
  • Posts: 71

Topic: Unable to print anything, Mechanical Problem

Over the past few days my 1.0 has developed this issue where it cannot print anything due to sort of shaking so to speak. Not sure how to explain it, I took a video:
[video]

Any ideas?

da Vinci 1.0
Repetier Firmware, E3D v6 Hot End
Successfully printed in: ABS, PLA, Ninjaflex, Nylon, and Woodfill

2 Reply by pbcrazy

  • pbcrazy
  • Member
  • Offline
  • Registered: 2015-01-05
  • Posts: 71

Re: Unable to print anything, Mechanical Problem

I also have the typical x-axis offset issue, may be unrelated. But it does seem like the shaking is due to the x-axis stepper/belt movement, I am not 100% on this as it is quite hard to tell though

da Vinci 1.0
Repetier Firmware, E3D v6 Hot End
Successfully printed in: ABS, PLA, Ninjaflex, Nylon, and Woodfill

3 Reply by pbcrazy

  • pbcrazy
  • Member
  • Offline
  • Registered: 2015-01-05
  • Posts: 71

Re: Unable to print anything, Mechanical Problem

Any ideas?

da Vinci 1.0
Repetier Firmware, E3D v6 Hot End
Successfully printed in: ABS, PLA, Ninjaflex, Nylon, and Woodfill