You are not logged in. Please login or register.
SoliForum - 3D Printing Community → Solidoodle Press → Pololu AVR Progammer
I am trying to reflash the firmware on my press, so I purchased this http://www.amazon.co.uk/Pololu-POL1300- … 84-21/url]
The programmer comes with a 6 pin plug and the jumper on the board only has 2 pins, please could someone let me know how this works? Do i need to purchase an additional cable/adapter to make it work/fit?
Many Thanks
the two pins next to the usb port is for the jumper, basically short those two together when you plug the usb cord in. the connector goes like this
but flip it so the ribbon cable goes to the right.
i can upload a picture of how to do it tomorrow if youd like, i need to reflash it anyway
i can upload a picture of how to do it tomorrow if youd like, i need to reflash it anyway
is the avr programer the only way of updating the press firmware? then i need to buy it also.
what kind of software needed? arduino?
i just used avr dude on ubutu, you should be able to do it on windows, check pages 9 through 11 on the e3d sticky
I used Arduino on mine. Worked like a charm.
Take a look at the picture in this thread: http://www.soliforum.com/topic/11338/ca … hat-i-try/
BUT the connector on the motherboard needs to be turned around 180 degrees from how it is in that picture!!!
THanks, did you get it working using Arduino software on the Mac, I found the jumper but couldn't get it to work, tried flip and arduino.
Yes, I did it with Arduino on the Mac.
SoliForum - 3D Printing Community → Solidoodle Press → Pololu AVR Progammer
Powered by PunBB, supported by Informer Technologies, Inc.
