1 Topic by webhaus

  • webhaus
  • Member
  • Offline
  • From: Orlando, FL
  • Registered: 2015-06-05
  • Posts: 15

Topic: Rolling back to 1.0.5 firmware from 1.0.6.. Is it possible?

I accidentally allowed the printer to upgrade firmwares from 1.0.5 to 1.0.6 when connecting to a new computer.  I have a DimensionBX bluetooth cartridge resetter, but it doesn't allow me to control temps in the 1.0.6 firmware.  has anyone been successful with a rollback?

Thanks for any help.  I've looked around a lot on the forums, and it's hard to work around all of the repetier posts when trying to read about firmware.  I'm not ready to switch over to repetier yet, which is why i'd rather just roll back.
-James

Davinci 1.0a grey
Stock firmware 1.0.6
Simplify 3d, Solidworks 2015
Side mounted cooling and fume extractor.

webhaus's Website

2 Reply by evanalmighty

  • evanalmighty
  • Member
  • Offline
  • Registered: 2015-01-04
  • Posts: 224

Re: Rolling back to 1.0.5 firmware from 1.0.6.. Is it possible?

I don't believe it's possible.  I think for now you should just wait until DBX update their tool once they can figure out a new workaround.