1 Topic by hansen644

  • hansen644
  • Member
  • Offline
  • Registered: 2014-09-10
  • Posts: 291

Topic: Bed continues to heat up past set point on davinci 1.0 ?

Hi, have been using repetier host and slicer for many months now on my davinci 1.0 all has been good till today.
The bed heater keeps heating up past set point and will not stop going up!  The bed is set for 107 and after I hit start print and the bed makes it to 107 and then the bed z moves down correctly the LCD sreen then switches to 220 degrees for the bed?  now the bed start to heat up trying to make it to 220 degrees!  help!!

2 Reply by carl_m1968

  • carl_m1968
  • carl_m1968
  • Member
  • Offline
  • From: Far North almost not Dallas
  • Registered: 2014-10-17
  • Posts: 6,512

Re: Bed continues to heat up past set point on davinci 1.0 ?

hansen644 wrote:

Hi, have been using repetier host and slicer for many months now on my davinci 1.0 all has been good till today.
The bed heater keeps heating up past set point and will not stop going up!  The bed is set for 107 and after I hit start print and the bed makes it to 107 and then the bed z moves down correctly the LCD sreen then switches to 220 degrees for the bed?  now the bed start to heat up trying to make it to 220 degrees!  help!!

You have the bed temp set for 220 in slicer. Sounds like you confused your bed temp and extruder temp. That or you did a mod to your firmware and some how swapped heater pins. The bed should have a high limit of 130 in firmware and should error if it goes above that.

Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.

3 Reply by carl_m1968

  • carl_m1968
  • carl_m1968
  • Member
  • Offline
  • From: Far North almost not Dallas
  • Registered: 2014-10-17
  • Posts: 6,512

Re: Bed continues to heat up past set point on davinci 1.0 ?

hansen644 wrote:

Hi, have been using repetier host and slicer for many months now on my davinci 1.0 all has been good till today.
The bed heater keeps heating up past set point and will not stop going up!  The bed is set for 107 and after I hit start print and the bed makes it to 107 and then the bed z moves down correctly the LCD sreen then switches to 220 degrees for the bed?  now the bed start to heat up trying to make it to 220 degrees!  help!!

You have the bed temp set for 220 in slicer. Sounds like you confused your bed temp and extruder temp. That or you did a mod to your firmware and some how swapped heater pins. The bed should have a high limit of 130 in firmware and should error if it goes above that.

Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.

4 Reply by hansen644

  • hansen644
  • Member
  • Offline
  • Registered: 2014-09-10
  • Posts: 291

Re: Bed continues to heat up past set point on davinci 1.0 ?

All fixed slicer setting were correct.   Just keep turning machine off and on. and just it just started working.  dont know why