1 Topic by cujo3131

  • cujo3131
  • Member
  • Offline
  • Registered: 2013-08-31
  • Posts: 97

Topic: Connection issues

Ok gang....

Not sure what is going on... but I seem to be having some
Connection issues.....

I am using a solidoodle 3....

Was connected a few minutes ago via port 4....

However I had to disconnect and reboot my machine....

Now I do not get port 4 at all.... Only Port 3...
it will connect to that... but I only get M105 connection errors...

Board lights are on... fan is running...

No connection sound when I plug in USB....

If I hit the reset button... it doesn't seem to do anything....
lights don't go out.... nothing... just keeps running....


Anyone have a clue?  I am stumped.....

2 Reply by heartless

  • heartless
  • heartless
  • Member
  • Offline
  • From: Northcentral Wisconsin
  • Registered: 2015-04-08
  • Posts: 2,152

Re: Connection issues

have you tried a different cable? sometimes the simplest thing.

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1

3 Reply by Manx

  • Manx
  • Member
  • Offline
  • Registered: 2012-09-25
  • Posts: 524

Re: Connection issues

i think i saw your post on face book un plug the cable turn the printer off then restart the computer and rehook everything and it should refind com 4

4 Reply by grob

  • grob
  • grob
  • Member
  • Offline
  • From: Sydney, Australia
  • Registered: 2014-01-02
  • Posts: 900

Re: Connection issues

This thread was reposted by the OP in Help/Repair/Maintenance.
See http://www.soliforum.com/topic/11193/connection-issues/

SD3. Mk2b + glass, heated enclosure, GT2 belts, direct drive y shaft, linear bearings, bowden-feed E3D v5 w/ 0.9° stepper
Smoothieboard via Octoprint on RPi