1 Topic by EnderV

  • EnderV
  • Member
  • Offline
  • Registered: 2015-01-28
  • Posts: 19

Topic: Bed probe has started crashing?

Hey guys,

I have been one of the few persons I feel who has had pretty good luck with the Press.
However, only until now. After a long print, it seems to not be working well anymore.
Whenever I start a print, the probing system fails. It usually only manages to get two in and by the third it crashes against the bed which I find rather odd. I figure if the auto bed leveling is broken, why would it get two in before crashing?
Any suggestions? I attached a video (not great quality) in case anyone wants to take a look.
So far I have only tried returning to factory settings.
The only thing I have tried so far is returning it to factory settings (soliprint) but it did nothing.
Any suggestions or theories?

2 Reply by pshcims

  • pshcims
  • Member
  • Offline
  • Registered: 2015-02-27
  • Posts: 84

Re: Bed probe has started crashing?

Your video doesn't appear, so it's hard to judge.

Have you run the z-calibration again?

3 Reply by EnderV

  • EnderV
  • Member
  • Offline
  • Registered: 2015-01-28
  • Posts: 19

Re: Bed probe has started crashing?

Sorry for the vid not showing.
I sort of fixed it.
I noticed that the prob was working..the button was not pushing down for that corner for some reason..I have to push it down. It seems to work but for some other prints..it seems that the bed is not well leveled. Is there any way I can calibrate/level the bed on my own without the probe?