Glad I Found This Forum

Hello there,

I received my Solidoodle Workbench and I can tell you, IT IS BIG!

I pre-order the printer and then waited 5 month to received it. The print bed arrived with a small, but significant, bent. So I had to wait an other month to receive the replacement part and to fix it myself. In my calibration procedure, I notice that one of the nozzle head was lower and would "scrape" off everything in its way. On my first print, the z axis of the printer was doing some backlash. Therefore, the first 5 layer was condense into barely 2 layer height.

I am now done fixing everything (I hope) and will start sharing my experience with this forum.

My though of the printer : The printer has great potential once dialed in.

Here is some info about me.
I live in Ontario, Canada
I am a student in electronic engineer.
Electronic, music and RC airplane are my hobbies.
My english is bad (but I'm working on it)

Ne vous inquiéter pas, je serais présent dans la section francophone.