1 Topic by worldburger

  • worldburger
  • Member
  • Offline
  • Registered: 2014-08-01
  • Posts: 47

Topic: POST: Example prints of Press print resolution?

I'm curious to see how other people's prints are coming out.

Anyone want to post some images of walls and details of your prints?

Coming from a MakerBot Replicator 2, I am disappointed with the inconsistent extrusion on my walls (even after reducing moire by adjusting the extrusion trimpot) and also strange cornering artifacts (it seems the front left and rear right have problems). I'll post some pics when I get my next print off.

2 Reply by MacGyverX

  • MacGyverX
  • MacGyverX
  • Member
  • Offline
  • From: Alexandria, VA
  • Registered: 2013-12-16
  • Posts: 445

Re: POST: Example prints of Press print resolution?

There is already a thread for this.

http://www.soliforum.com/topic/10109/po … ur-prints/

SD Press - v1 (Pre-order) / RAMPs /w DRV8825's / Cyclops (25w) / Dual Bowden / Mk8 Gear / MK2b PCB Heat bed /w custom replacement Z / PEI Bed
SD2 / E3D v6 / Direct Drive / Mk8 Gear / RAMBo v1.3 / PEI Bed / Anti Z backlash mod / Ikea Expedite enclosure.
Both Driven by Octoprint (devel) via a RPi B+ / Neopixel status alerts / GPIO Controlled SSR / (SD2) 450 Watt PSU for remote power-up/shutdown.