1 Topic by aaronboo (edited by aaronboo 2015-03-10 08:20:44)

  • aaronboo
  • Member
  • Offline
  • Registered: 2012-11-23
  • Posts: 34

Topic: Issues with Extruder Motor <Solved>

https://www.dropbox.com/s/o4zk8zqbt9fui … r.mp4?dl=0

Hello, can anyone advice on this? Despite restarting my Press, my extruder motor is not able to operate normally.

2 Reply by tomkwc

  • tomkwc
  • Member
  • Offline
  • Registered: 2015-02-08
  • Posts: 12

Re: Issues with Extruder Motor <Solved>

Looks like the classic issue with loose wire from the extruder stepper motor connector left most pin. The tension caused it to become loose. Total design flaw.

3 Reply by aaronboo

  • aaronboo
  • Member
  • Offline
  • Registered: 2012-11-23
  • Posts: 34

Re: Issues with Extruder Motor <Solved>

Thanks! it is the cable that is damaged.