You are not logged in. Please login or register.
SoliForum - 3D Printing Community → XYZ Printing DaVinci → Cannot downgrade firmware
Hey guys I am going to get a filament resetter for my DaVinci 1.0, and based on my research the firmware has to be lower than or equal to version "J", problem is I accidentally let it upgrade my printer to the latest firmware yesterday to 1.2.5 (see attached), and when I tried to downgrade it with the internet disabled the printer refused to accept the old firmware the simply says update failed on the LCD. Any ideas/suggestions?
Thanks a lot!!!
You need to short out JP1 and then push the J firmware to it with arduino IDE.
You need to short out JP1 and then push the J firmware to it with arduino IDE.
Hum...sounds harder than I thought it would be, where can I find the tutorial?
http://www.wctek.com/shop/content/9-downloads
You need to download DAVINCI_1_0_RESET.zip. The tutorial is in the zip file. It has every thing you need to do it except arduino IDE which can be downloaded on arduino a website.
I did it and it was actually pretty easy even though it seems hard.
Did you have any luck with that?
You need to download DAVINCI_1_0_RESET.zip. The tutorial is in the zip file. It has every thing you need to do it except arduino IDE which can be downloaded on arduino a website.
I did it and it was actually pretty easy even though it seems hard.
Problem solved!!! Thanks a lot!!!! I will block the xyzware from accessing the internet from now on so I won't accidentally click the annoying upgrade button again. Thanks again!
No problem. Also if you downgrade to 1.1.E and use the open xyzware mod you don't need the resetter.
Sweet! I thought it was the printer firmware itself that counts the remaining filament, right I will look into it. Also I have been thinking about raising the printer bed temperature for a while coz the sticking issue has been very annoying and so far what I've heard is either get some print bed tape or rise the print bed temperature, except I live too far away from the US so it will cost me an arm and a leg to ship some over, I guess some modded xyzware might do the trick.
Do you need a link for open xyzware?
That would be AWESOME!!!
http://voltivo.com/forum/davinci-softwa … e-open-mod Calibrate your printer before you print for the first time. Happy printing!
And you also need to download slic3r. You should be able to find that by googling it.
Ye I came across that mod and have put that down as one of the candidates, looks like I should go back and have second look, thanks a lot man I will look into it and hopefully that would solve all these filament cost and ABS not stick onto the print bed issue in one go. Thanks a lot!
SoliForum - 3D Printing Community → XYZ Printing DaVinci → Cannot downgrade firmware
Powered by PunBB, supported by Informer Technologies, Inc.
