1 Topic by Robny (edited by Robny 2015-03-04 21:56:46)

  • Robny
  • Member
  • Offline
  • Registered: 2014-08-25
  • Posts: 89

Topic: RH Bed Probe

Hello All

I edited the start code as suggested by Soliryan in previous threads, but when using RH with the new start code, it is probing the bed two sets before starting printing, is this correct or did I do something wrong?

I put the start code in the preview edit start code but i ALSO put it in the Slicer config, could that be the reason?

Thanks Again

2 Reply by jagowilson

  • jagowilson
  • PRINTiT
  • Offline
  • Registered: 2014-09-14
  • Posts: 1,701

Re: RH Bed Probe

You only need it in one place. Putting the code in both spots puts it in the print twice.

3 Reply by Robny

  • Robny
  • Member
  • Offline
  • Registered: 2014-08-25
  • Posts: 89

Re: RH Bed Probe

jagowilson wrote:

You only need it in one place. Putting the code in both spots puts it in the print twice.

Thank you

This has resolved it