1 Topic by aaronboo

  • aaronboo
  • Member
  • Offline
  • Registered: 2012-11-23
  • Posts: 34

Topic: Bed Leveling on Press (Calibration Points)

Hello Everyone,

Not too sure if you guys face the same issue. The area within the 9 points which the Printer Probes sticks perfectly fine, been using Hair Spray, printing at 100 Degrees for the Bed. However with prints larger than the 9 points, the material just doesn't stick as the bed is too far from the nozzle. Anyway of increasing the number of calibration points?

Anyone can give me quick guide on how to do this. Flashing Printrboard firmware was pretty simple, but not too sure how the Press Motherboard works.