1 Topic by jasonb.194

  • jasonb.194
  • Member
  • Offline
  • Registered: 2015-01-20
  • Posts: 67

Topic: Extruder losing heat after print starts

The last few print i have tried started well, then suddenly there was clicking. I noticed that the temp of the extruder was falling significantly.

I am thinking that it is an issue with the hot end connector, but shouldnt that show an 0011 or 0010 error?

Has anyone seen this before?

2 Reply by scotthay

  • scotthay
  • Member
  • Offline
  • From: Cincinnati, Ohio
  • Registered: 2014-08-30
  • Posts: 79

Re: Extruder losing heat after print starts

The black cable connector to your heater is going bad, replace it with a deans type and your problem will go away, this is a well known problem with this machine.