1 Topic by OneMoreCast

  • OneMoreCast
  • OneMoreCast
  • Member
  • Offline
  • From: Long Island, NY
  • Registered: 2015-01-02
  • Posts: 334

Topic: Jagowilson's circle test results

To me they look good...if anybody else has done test lets see your results (if this is in wrong spot sorry mods)

http://s4.postimg.org/s5fty5co9/image.jpg

"All your base are belong to us." SD4 with a RUMBA, supernight PS, 40mm fan on X motor, lawsey carriages with new better tolerance rods, flanged rear bearings, new NEMA 17 with leadscrew on Z-Axis, and e3d v6 with MK5.


Ward and Jago are my heroes tongue

OneMoreCast's Website

2 Reply by ben1272

  • ben1272
  • Newbie
  • Offline
  • Registered: 2014-09-13
  • Posts: 2

Re: Jagowilson's circle test results

Attached is a photo of my circle test.  I did have to do a significant x-y belt adjustment in order to get it finally making round circles.  The key piece of information that helped me was that the belts should not snap or vibrate when the printer changes direction...they should just cleanly start moving the other way, otherwise they are too loose. 

Sorry photo is not embedded in post...not sure how to do it.

-Ben

Post's attachments

circle test.JPG
circle test.JPG 28.93 kb, file has never been downloaded. 

You don't have the permssions to download the attachments of this post.