1 Topic by pbcrazy

  • pbcrazy
  • Member
  • Offline
  • Registered: 2015-01-05
  • Posts: 71

Topic: Keeping ABS filament dry?

How do you guys keep the filament dry? Atm I have them stored in the original cardboard boxes with the silica packet that comes on the outside of the cartridges. I doubt this is very effective, but most solutions are for the spools not these cartridges.

da Vinci 1.0
Repetier Firmware, E3D v6 Hot End
Successfully printed in: ABS, PLA, Ninjaflex, Nylon, and Woodfill

2 Reply by rforeman (edited by rforeman 2015-01-26 02:11:16)

  • rforeman
  • Member
  • Offline
  • Registered: 2014-09-16
  • Posts: 59

Re: Keeping ABS filament dry?

I keep mine in a large Rubber Made tub with 2
Damprid containers
http://www.amazon.com/DampRid-FG60-Refi … B002MPPYU2

A little over kill but it works well.