1 Topic by Muledog17

  • Muledog17
  • Member
  • Offline
  • From: NJ USA
  • Registered: 2014-12-31
  • Posts: 69

Topic: Slic3r moves to fast

I tried to slice a file with slic3r and it starts printing but moves so fast it wont stick to the bed.  I attached the .3w file.

2 Reply by carl_m1968 (edited by carl_m1968 2015-01-25 06:10:16)

  • carl_m1968
  • carl_m1968
  • Member
  • Offline
  • From: Far North almost not Dallas
  • Registered: 2014-10-17
  • Posts: 6,512

Re: Slic3r moves to fast

Muledog17 wrote:

I tried to slice a file with slic3r and it starts printing but moves so fast it wont stick to the bed.  I attached the .3w file.


After you slice the file did you open it in notepad++ and change all the G0 commands to G1? Then convert to base64.

Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.

3 Reply by Muledog17

  • Muledog17
  • Member
  • Offline
  • From: NJ USA
  • Registered: 2014-12-31
  • Posts: 69

Re: Slic3r moves to fast

No I will try that now.

4 Reply by Muledog17

  • Muledog17
  • Member
  • Offline
  • From: NJ USA
  • Registered: 2014-12-31
  • Posts: 69

Re: Slic3r moves to fast

So i tried that but now the print head sits over the drip box and after about 5 minutes it says its done.  Any ideas?