1 Topic by georgehine

  • georgehine
  • Member
  • Offline
  • Registered: 2014-11-29
  • Posts: 109

Topic: calibration issues!

just wondering if there is any way to adjust the extrusion speed with the stock xyzware. I printed a test piece http://www.thingiverse.com/download:614998
then I checked the thickness of the walls with a micrometer. The wall thickness should be 0.4 and I get a printed part with a side wall of 0.48


I tryed to use xyzware open mod but it crashes if I try to print or export.

Da Vinci 1.0 stock firmware and stock xyzware.
3D printer Noob.
Stock ABS filaments

2 Reply by tonyno

  • tonyno
  • Member
  • Offline
  • Registered: 2014-12-23
  • Posts: 135

Re: calibration issues!

There is a lot that you can't adjust with the stock setup. That said, it works pretty well once you calibrate the bed, and, adjust your parts to match what's coming out. Just printing stuff from others won't be correct, though. It would be nice if they fixed this.