1 Topic by satman49

  • satman49
  • Member
  • Offline
  • From: virginia
  • Registered: 2012-12-28
  • Posts: 867

Topic: ARDUINO 1.0.6

I want to update the firmware on a rumba  board but  do not see that board listed  in tools.Which  other could I chose?

SD3, E3D hotend,linear bearing on x/y axis',pillow block bearing on y conneting rod, ball bearngs on front y axis, fan on y stepper motor.

2 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: ARDUINO 1.0.6

ATMEGA xxxx I don't remember the numbers.

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website

3 Reply by accusedmonk

  • accusedmonk
  • Member
  • Offline
  • Registered: 2013-10-22
  • Posts: 253

Re: ARDUINO 1.0.6

ATMEGA 2560 I believe.  I'm wiring up my rumba and will be flashing it hopefully within the next couple hours.  I should have a USB that will fit it.

Bowden SD3, Rumba, E3D hotend, Mk5 with RtRyder changes, Direct drive Y axis and bearings, GT2 pulleys and braided fishing line, Lawsy linear bearing conversion, M3 Z screw.

4 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: ARDUINO 1.0.6

Thats it 2560 smile

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website