1 Topic by Irish

  • Irish
  • Member
  • Offline
  • Registered: 2012-12-07
  • Posts: 104

Topic: Where to locate the Solidoodle2 .1mm.ini and .3mm.ini files?

I've gotten past all my past issues except I'm waiting for the Kapton tape. In the meantime I thought I'd finish installing the Repetier-Host software on my laptop which will be the control computer for the SD2. Trouble is I can't find where to locate the two ini files necessare for switching between .1mm and .3mm printing. I know this was specified somewhere but I can't find that reference after searching this Forums and also re-reading over and over the installation instructions.

Can someone tell me which sub-directory that these files need to be placed in under Slc3r? I'n not finding any sub-directories with 'ini' extension files.

2 Reply by devilman2075

  • devilman2075
  • Member
  • Offline
  • Registered: 2012-08-21
  • Posts: 154

Re: Where to locate the Solidoodle2 .1mm.ini and .3mm.ini files?

You don't need to put them anywhere specific.  Personally I made a folder for all the slicer config files I have butyoujust need to load the profiles,  it doesn't matter where they are

3 Reply by Irish

  • Irish
  • Member
  • Offline
  • Registered: 2012-12-07
  • Posts: 104

Re: Where to locate the Solidoodle2 .1mm.ini and .3mm.ini files?

Somewhere I got the impression they were picked up automatically by Slc3r and displayed in a drop down list. This isn't the case?

4 Reply by Irish

  • Irish
  • Member
  • Offline
  • Registered: 2012-12-07
  • Posts: 104

Re: Where to locate the Solidoodle2 .1mm.ini and .3mm.ini files?

Thanks Devilman, it's all installed and ready to go, that is, when I get the Kapton Tape on Monday. Otherwise it's firmware upgraded and new software installed.