1 Topic by skateguy2000

  • skateguy2000
  • Newbie
  • Offline
  • Registered: 2014-08-12
  • Posts: 3

Topic: Stock SD4 Firmware

Hello! I was wondering if anyone has the stock firmware for SD4. I just want to tweak it a little but I cant find it on the solidoodle website.

Thanks,
H

2 Reply by MacGyverX

  • MacGyverX
  • MacGyverX
  • Member
  • Offline
  • From: Alexandria, VA
  • Registered: 2013-12-16
  • Posts: 445

Re: Stock SD4 Firmware

Its not 'Stock' but it will work.

https://github.com/ozadr1an/Solidoodle-Marlin_v1

SD Press - v1 (Pre-order) / RAMPs /w DRV8825's / Cyclops (25w) / Dual Bowden / Mk8 Gear / MK2b PCB Heat bed /w custom replacement Z / PEI Bed
SD2 / E3D v6 / Direct Drive / Mk8 Gear / RAMBo v1.3 / PEI Bed / Anti Z backlash mod / Ikea Expedite enclosure.
Both Driven by Octoprint (devel) via a RPi B+ / Neopixel status alerts / GPIO Controlled SSR / (SD2) 450 Watt PSU for remote power-up/shutdown.

3 Reply by grob

  • grob
  • grob
  • Member
  • Offline
  • From: Sydney, Australia
  • Registered: 2014-01-02
  • Posts: 900

Re: Stock SD4 Firmware

MacGyverX wrote:

Its not 'Stock' but it will work.

https://github.com/ozadr1an/Solidoodle-Marlin_v1

Yup, you want this one. For starters, the addition of hysteresis correction was a big step in the right direction for me!

SD3. Mk2b + glass, heated enclosure, GT2 belts, direct drive y shaft, linear bearings, bowden-feed E3D v5 w/ 0.9° stepper
Smoothieboard via Octoprint on RPi