1 Topic by chadheinen

  • chadheinen
  • Newbie
  • Offline
  • Registered: 2014-03-26
  • Posts: 4

Topic: Slic3r questions

I have downloaded this .stl from thingaverse, but when Slic3r tries to slice it hangs up when doing the perimeters. Any ideas. Thanks
Chad

Post's attachments

HorseCookieCutteruntitled.STL 1 mb, 7 downloads since 2014-07-16 

You don't have the permssions to download the attachments of this post.

2 Reply by wire10ga

  • wire10ga
  • wire10ga
  • Member
  • Offline
  • From: Arkansas
  • Registered: 2012-09-14
  • Posts: 665

Re: Slic3r questions

Try the attached.  I always run thingiverse stuff through NetFab https://netfabb.azurewebsites.net/ or if you dont want to register, download the free version here http://www.netfabb.com/downloadcenter.php?basic=1

Post's attachments

HorseCookieCutteruntitled (repaired).stl 1 mb, 2 downloads since 2014-07-17 

You don't have the permssions to download the attachments of this post.
SD2 - Glass Bed, Fans on PCB and Y motor, Custom enclosure
Slicer - Simplify3D

wire10ga's Website

3 Reply by Tomek (edited by Tomek 2014-07-17 16:42:34)

  • Tomek
  • Member
  • Offline
  • Registered: 2012-10-01
  • Posts: 710

Re: Slic3r questions

wire10ga wrote:

Try the attached.  I always run thingiverse stuff through NetFab https://netfabb.azurewebsites.net/ or if you dont want to register, download the free version here http://www.netfabb.com/downloadcenter.php?basic=1

Oh,interesting.  When did netfabb switch from Cloud.Netfabb.com?

on another note,
For some reason when I click your link it directs me to the website without the colon between s and // of https://