1 Topic by Downeasta

  • Downeasta
  • Downeasta
  • Member
  • Offline
  • From: Near - Ellsworth Maine
  • Registered: 2013-06-16
  • Posts: 120

Topic: Repetier Host setup info (where did it go?)

I remember Lawsy doing some settings for the Repetier setup.  Can some one link me where to go again?

I am finally seeing the possibility of getting a printer (sorry not solidoodle).  So I am trying to get repetier set up in advance.

Thankyou for your time.

I am an open book, write on my pages that I may learn the wisdom that you posses.

Downeasta's Website

2 Reply by IronMan

  • IronMan
  • IronMan
  • PRINTiT
  • Offline
  • From: SC
  • Registered: 2012-09-14
  • Posts: 1,269

Re: Repetier Host setup info (where did it go?)

Here is the thread for RH and Solidoodle...the basics should be similar on other printers.

http://www.soliforum.com/topic/121/repe … olidoodle/

The first post in the thread contains another link to Ian's Wordpress site where he goes through the setup...

SD2 - Stock - Enclosure - Heated Bed - Glass Plate - Auto Fire Extinguisher
Ord Bot Hadron - RAMPS 1.4 - Bulldog XL - E3D v6 - 10" x 10" PCB Heated Build w/SSR - Glass Plate
Thanks for All of Your Help!

3 Reply by Downeasta

  • Downeasta
  • Downeasta
  • Member
  • Offline
  • From: Near - Ellsworth Maine
  • Registered: 2013-06-16
  • Posts: 120

Re: Repetier Host setup info (where did it go?)

My thanks to you.  This is what I was looking for.

I am an open book, write on my pages that I may learn the wisdom that you posses.

Downeasta's Website