1 Topic by forrestmc4

  • forrestmc4
  • Newbie
  • Offline
  • Registered: 2013-05-04
  • Posts: 7

Topic: What are you working on?

I've had my SD3 for over a year now and have loved working and learning with it. I'm currently in the middle of working on the Crossfire 2 open-source quad rotor (search it on thingiverse). Are there any substantial projects that you guys are using your printers for?

I have a few weeks free and would like a new project to work on once I finish the quad.

2 Reply by grob

  • grob
  • grob
  • Member
  • Offline
  • From: Sydney, Australia
  • Registered: 2014-01-02
  • Posts: 900

Re: What are you working on?

Have a search on thingiverse for mechanical clocks. I'm designing one, but have deliberately avoided searching for existing designs as the temptation to cheat and fail to understand escapements would be too high!

I figure it might be a good test of your extrusion accuracy, circles, and patience. smile

SD3. Mk2b + glass, heated enclosure, GT2 belts, direct drive y shaft, linear bearings, bowden-feed E3D v5 w/ 0.9° stepper
Smoothieboard via Octoprint on RPi