1 Topic by JustSomeGuyTN

  • JustSomeGuyTN
  • Member
  • Offline
  • Registered: 2012-08-31
  • Posts: 158

Topic: Using Slic3r with Repieter, the right hand side is off by 10mm or so

When I'm using Slic3r to print it seems like it sees the center of my bed as around 10mm to the right.  So if a print is big enough or oriented so that it needs to print on the right 10mm or so of the bed it prints off the edge instead.  Could someone point me to the setting I need to change to fix that?

2 Reply by IanJohnson

  • IanJohnson
  • Moderator
  • Offline
  • Registered: 2012-08-07
  • Posts: 2,815

Re: Using Slic3r with Repieter, the right hand side is off by 10mm or so

Try setting the bed width to159.  The bed is 150, but with the gap on the right side, there is 159 or so of travel in the X axis.