YSB print bust of "The Huntress" and friend

**ggunners** · 2014-02-10 21:43:21

ggunners
Member
Offline

From: Chantilly, VA USA
Registered: 2013-12-03
Posts: 170

Topic: YSB print bust of "The Huntress" and friend

Printed another YSB subject bust of The Huntress.

Made this one at 80% of actual and .200 mm layer height. After looking at the 3D image, the chin of the large cat seemed to be hanging in space, so I decided to print it with supports and used KISSlicer.

It turned out pretty well except from the Huntress upper lip upward, I had more visible banding than below that point. I'm not sure why it became a bit worse at that height. Overall, I am very happy with the print. -- ggunners

Post's attachments

20140210-huntress.jpg
20140210-huntress.jpg 76.69 kb, file has never been downloaded.

You don't have the permssions to download the attachments of this post.

SD2 Expert stock, ABS fume fan,
XYZ DaVinci 1.0 stock ABS, Simplify3D
QUBD Two-Up PLA, new 3D printed X gantry, Y idler, flex z coupler, extruder mount, E3D Lite

**ysb** · 2014-02-11 13:06:10

ysb
Member
Offline

From: quebec, canada
Registered: 2012-08-09
Posts: 1,164

Re: YSB print bust of "The Huntress" and friend

...yes... the inferior jaws slope of the panther is a bit too much for 0.2mm...but it can be printed ...i think i do it with 0.18mm layers, it's not a lot less but that do the trick...

dispite this, nice print ...

ps: I just finished building my new printer yesterday ... "THE" project will finally be able to advance

Find all my 3D printable models here
Game of ropes 2 online..Adult only

**DesignerFred** · 2014-02-11 19:17:52

DesignerFred
Member
Offline

From: France
Registered: 2013-03-19
Posts: 264

Re: YSB print bust of "The Huntress" and friend

ggunners wrote:

Printed another YSB subject bust of The Huntress.
Made this one at 80% of actual and .200 mm layer height. After looking at the 3D image, the chin of the large cat seemed to be hanging in space, so I decided to print it with supports and used KISSlicer.
It turned out pretty well except from the Huntress upper lip upward, I had more visible banding than below that point. I'm not sure why it became a bit worse at that height. Overall, I am very happy with the print. -- ggunners

Nice job

www.designerfred.fr before: Solidoodle 2 + E3D v6 now: MeCreator II and OLO 3D

YSB print bust of "The Huntress" and friend

Posts: 3

1 Topic by ggunners 2014-02-10 21:43:21 (edited by ggunners 2014-02-10 21:53:34)

Topic: YSB print bust of "The Huntress" and friend

2 Reply by ysb 2014-02-11 13:06:10

Re: YSB print bust of "The Huntress" and friend

3 Reply by DesignerFred 2014-02-11 19:17:52

Re: YSB print bust of "The Huntress" and friend

Posts: 3