1 Topic by Itwistknobs

  • Itwistknobs
  • Newbie
  • Offline
  • Registered: 2014-01-31
  • Posts: 7

Topic: Hello everyone.

I'm new to 3D printing, but not new to engineering fixes for broken stuff. I am learning so much from all of you. Thanks for sharing all your expertise!

2 Reply by ronsii

  • ronsii
  • Member
  • Offline
  • From: PNW
  • Registered: 2012-10-28
  • Posts: 1,723

Re: Hello everyone.

Welcome Itwistknobs smile

Glad to hear you are learning from the forum.

3 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: Hello everyone.

Welcome to the forum,
Just wondering....Do you actually twist knobs?

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website

4 Reply by ITman496

  • ITman496
  • Member
  • Offline
  • Registered: 2013-07-16
  • Posts: 288

Re: Hello everyone.

http://i.imgur.com/fSV89.gif

5 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: Hello everyone.

That's too funny!

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website

6 Reply by ronsii

  • ronsii
  • Member
  • Offline
  • From: PNW
  • Registered: 2012-10-28
  • Posts: 1,723

Re: Hello everyone.

For a second there I thought you had a feed from my webcam!!! wink

7 Reply by ITman496

  • ITman496
  • Member
  • Offline
  • Registered: 2013-07-16
  • Posts: 288

Re: Hello everyone.

I need some red alarm lights for my room..