1 Topic by AZERATE

  • AZERATE
  • AZERATE
  • PRINTiT
  • Offline
  • From: Chicago
  • Registered: 2013-11-28
  • Posts: 2,077

Topic: .08 Slic3r setting?

Thinking about trying it. On larger print .1 is wonderful or at least acceptable.
But is there is risk with this fiddling? I know Solidoodle states SD2 can print "up to" .1, but is it a bad idea to attempt to push it further? Would Slicer even recognize it?
Figure I should ask the pros before I jack everything up.

Printit Mason and Printit Horizon printers
Multiple SD2s- Bulldog XL, E3D v5/v6/Lite6, Volcano, Hobb Goblin, Titan, .9 motor, Lawsy carriages, direct Y drive, fishing line...the list goes on
Filawinder and Filastruder #1870.....worth every penny!

2 Reply by ronsii

  • ronsii
  • Member
  • Offline
  • From: PNW
  • Registered: 2012-10-28
  • Posts: 1,723

Re: .08 Slic3r setting?

Why not go to .05"

3 Reply by AZERATE

  • AZERATE
  • AZERATE
  • PRINTiT
  • Offline
  • From: Chicago
  • Registered: 2013-11-28
  • Posts: 2,077

Re: .08 Slic3r setting?

Would I risk damaging anything though? I'm still new at this, so I don't even know if this is either possible or dumbest question of the decade.

Printit Mason and Printit Horizon printers
Multiple SD2s- Bulldog XL, E3D v5/v6/Lite6, Volcano, Hobb Goblin, Titan, .9 motor, Lawsy carriages, direct Y drive, fishing line...the list goes on
Filawinder and Filastruder #1870.....worth every penny!

4 Reply by ronsii

  • ronsii
  • Member
  • Offline
  • From: PNW
  • Registered: 2012-10-28
  • Posts: 1,723

Re: .08 Slic3r setting?

I believe someone here has done .05... maybe 2n2 or Ian??? I tried it once but before I could get things zeroed in I got too impatient wink and went on to other things...

5 Reply by AZERATE

  • AZERATE
  • AZERATE
  • PRINTiT
  • Offline
  • From: Chicago
  • Registered: 2013-11-28
  • Posts: 2,077

Re: .08 Slic3r setting?

Thank you very much!

Printit Mason and Printit Horizon printers
Multiple SD2s- Bulldog XL, E3D v5/v6/Lite6, Volcano, Hobb Goblin, Titan, .9 motor, Lawsy carriages, direct Y drive, fishing line...the list goes on
Filawinder and Filastruder #1870.....worth every penny!

6 Reply by jawhn

  • jawhn
  • jawhn
  • Member
  • Offline
  • Registered: 2013-03-12
  • Posts: 77

Re: .08 Slic3r setting?

Also think about how long that will take to print, I get impatient with .3, lol.

Two SD3s - One with Sang, One with Printrboard, Fans on control boards!!! Do this!!!, Dual Glass Beds, Blacklight "EZ Bake Oven" - Improves Ambient Temp, Sketchup, Repetier, Slic3r. Graphic Designer & Makeshift Engineer. Drinks Lots and Lots and Lots of Rum.