1 Topic by allanme79

  • allanme79
  • Newbie
  • Offline
  • Registered: 2013-12-19
  • Posts: 5

Topic: Need Help with software

OK first here is the disclaimer. I know very little about software and installing it. I have a Solidoodle 2 printer and I am working on 64bit windows 7 enterprise Dell Computer. I have had this printer for abotu 3 months now. I have been able to print several things however now it won't print. I am able to heat the tip, extrude, and move the printer head manually. However, when I click on slice and run nothing happens. It does look like it is slicing but then it won't print afterwards. I uninstalled repetier 90 and installed the latest program. I am not sure what to do. It didn't work on the old version and it won't work on the new.

Any help would be great.

2 Reply by rjp350z

  • rjp350z
  • rjp350z
  • Member
  • Offline
  • From: Bloomfield, NJ
  • Registered: 2013-01-11
  • Posts: 249

Re: Need Help with software

does the log file show any error messages? Can you get a screen capture of the log file

3 Reply by allanme79

  • allanme79
  • Newbie
  • Offline
  • Registered: 2013-12-19
  • Posts: 5

Re: Need Help with software

If you are talking about the GCode Editor I am not seeing anthing that says error.

4 Reply by rjp350z (edited by rjp350z 2013-12-19 18:38:01)

  • rjp350z
  • rjp350z
  • Member
  • Offline
  • From: Bloomfield, NJ
  • Registered: 2013-01-11
  • Posts: 249

Re: Need Help with software

There is a bottom box in repetier that shows the log messages. I'm not at my printer right now so can not do a screen capture for you.

Check attached screen cap....

Post's attachments

Repetier.bmp 3.65 mb, 9 downloads since 2013-12-19 

You don't have the permssions to download the attachments of this post.

5 Reply by allanme79

  • allanme79
  • Newbie
  • Offline
  • Registered: 2013-12-19
  • Posts: 5

Re: Need Help with software

No I don't see anything that says error. Just N3501 then it starts ascending in count

6 Reply by rjp350z

  • rjp350z
  • rjp350z
  • Member
  • Offline
  • From: Bloomfield, NJ
  • Registered: 2013-01-11
  • Posts: 249

Re: Need Help with software

Have you scrolled up to see if any errors appear at the start?

7 Reply by allanme79

  • allanme79
  • Newbie
  • Offline
  • Registered: 2013-12-19
  • Posts: 5

Re: Need Help with software

I restarted the computer and reconnected it and tried to reload and now I do see some errors.  It says Error: No Checksum with line number, last line 45 then it says on the nxt line Error: Line Number is not the last line number +1, Last Line:45