1 Topic by satman49

  • satman49
  • Member
  • Offline
  • From: virginia
  • Registered: 2012-12-28
  • Posts: 867

Topic: extruder anchor

I updated the firmware for my sd3( not the newest) Still using RH 90c. Now it extrudes the anchor in the wrong place( says x 145 y 145., not in upper right corner as before.I have looked for a solution but no luck.Does anybody know what I need to change to correct that?

SD3, E3D hotend,linear bearing on x/y axis',pillow block bearing on y conneting rod, ball bearngs on front y axis, fan on y stepper motor.

2 Reply by Rincewind

  • Rincewind
  • Member
  • Offline
  • Registered: 2012-10-16
  • Posts: 334

Re: extruder anchor

satman49 wrote:

I updated the firmware for my sd3( not the newest) Still using RH 90c. Now it extrudes the anchor in the wrong place( says x 145 y 145., not in upper right corner as before.I have looked for a solution but no luck.Does anybody know what I need to change to correct that?

X145 Y145 should be in the upper right corner. Where is it extruding instead?

3 Reply by satman49

  • satman49
  • Member
  • Offline
  • From: virginia
  • Registered: 2012-12-28
  • Posts: 867

Re: extruder anchor

Here is a representation of where it is.

Post's attachments

extpos.jpg 32.18 kb, file has never been downloaded. 

You don't have the permssions to download the attachments of this post.
SD3, E3D hotend,linear bearing on x/y axis',pillow block bearing on y conneting rod, ball bearngs on front y axis, fan on y stepper motor.

4 Reply by cozierad

  • cozierad
  • Member
  • Offline
  • Registered: 2013-07-21
  • Posts: 33

Re: extruder anchor

satman49 wrote:

I updated the firmware for my sd3( not the newest) Still using RH 90c. Now it extrudes the anchor in the wrong place( says x 145 y 145., not in upper right corner as before.I have looked for a solution but no luck.Does anybody know what I need to change to correct that?

On an SD2 145 and 145 are correct but not for an sd3. Larger bed that is approx 200 by 200. try something closer to X 195 Y195

5 Reply by satman49 (edited by satman49 2013-12-10 23:59:26)

  • satman49
  • Member
  • Offline
  • From: virginia
  • Registered: 2012-12-28
  • Posts: 867

Re: extruder anchor

I am confused(lol not hard to do) , where would I change that? Being that I updated the firmware( was ok before that), I was thinking it might be a value change in Marlin. I have looked but really don't know where that might be.

SD3, E3D hotend,linear bearing on x/y axis',pillow block bearing on y conneting rod, ball bearngs on front y axis, fan on y stepper motor.

6 Reply by satman49

  • satman49
  • Member
  • Offline
  • From: virginia
  • Registered: 2012-12-28
  • Posts: 867

Re: extruder anchor

THANKS cozierad, that did the trick.

SD3, E3D hotend,linear bearing on x/y axis',pillow block bearing on y conneting rod, ball bearngs on front y axis, fan on y stepper motor.