1 Topic by satman49

  • satman49
  • Member
  • Offline
  • From: virginia
  • Registered: 2012-12-28
  • Posts: 867

Topic: annoying extruder temp proplem

I am using  RH .90C. In the printer setting and in sli3r I have it set  to 190.All is well til I click RUN in RH, then it changes  195. I can't find where its getting that figure.

SD3, E3D hotend,linear bearing on x/y axis',pillow block bearing on y conneting rod, ball bearngs on front y axis, fan on y stepper motor.

2 Reply by 3d-oodler

  • 3d-oodler
  • Member
  • Offline
  • Registered: 2013-02-06
  • Posts: 230

Re: annoying extruder temp proplem

Check the custom gcode section in slic3r