26 Reply by 2n2r5

  • 2n2r5
  • 2n2r5
  • Member
  • Offline
  • From: Frederick, MD
  • Registered: 2013-05-09
  • Posts: 1,208

Re: blobby rough surface

Your Z steps/mm should be 2267.7183

SD3 w/ mods:
Glass bed with QU-BD heat pad upgrade, threadless ballscrew w/ 8mm smooth rod, spectra line belt replacement, lawsy MK5 extruder, Lawsy replacement carriage, E3D hotend, Ramps 1.4 w/ reprap discount controller, DRV8825 drivers, 12v 30A PS, Acrylic case, Overkill Y-idlers, Filament alarm, Extruder fan + more.

2n2r5's Website

27 Reply by ronsii

  • ronsii
  • Member
  • Offline
  • From: PNW
  • Registered: 2012-10-28
  • Posts: 1,723

Re: blobby rough surface

diyengineer wrote:

My z height was off from the factory also. tisk tisk!


You mean the z zero height or the actual steps per mm? as mine have all been spot on.