26 Reply by techbuilder2175

  • techbuilder2175
  • techbuilder2175
  • Member
  • Offline
  • Registered: 2013-07-22
  • Posts: 338

Re: filamaker

Of course Tim

as you know a motor would increase the cost dramatically

Powder coated steel enclosure, 1/4" Surface grounded hardened aluminum plate, MK2A Heat bed, .200 Polished fused quartz plate, Machined quick change hot bed mount, E3D hot end, Ramps 1.4, DRV8825 stepper motor drivers

27 Reply by elmoret

  • elmoret
  • Filastruder
  • Offline
  • Registered: 2012-10-11
  • Posts: 6,048

Re: filamaker

Well I didn't know if a hand crank would be included in that price - that's what I was asking.

Filastruder - the robust, inexpensive filament extruder
E3Dv6 All Metal Hotend - the premier 3D printing hotend

28 Reply by techbuilder2175

  • techbuilder2175
  • techbuilder2175
  • Member
  • Offline
  • Registered: 2013-07-22
  • Posts: 338

Re: filamaker

Sorry about that Tim I assumed.

Powder coated steel enclosure, 1/4" Surface grounded hardened aluminum plate, MK2A Heat bed, .200 Polished fused quartz plate, Machined quick change hot bed mount, E3D hot end, Ramps 1.4, DRV8825 stepper motor drivers

29 Reply by techbuilder2175

  • techbuilder2175
  • techbuilder2175
  • Member
  • Offline
  • Registered: 2013-07-22
  • Posts: 338

Re: filamaker

If I can get 10 orders I could probably decrease the cost by an additional 50 dollars

Powder coated steel enclosure, 1/4" Surface grounded hardened aluminum plate, MK2A Heat bed, .200 Polished fused quartz plate, Machined quick change hot bed mount, E3D hot end, Ramps 1.4, DRV8825 stepper motor drivers

30 Reply by DePartedPrinter

  • DePartedPrinter
  • Moderator
  • Offline
  • From: Colorado
  • Registered: 2012-08-14
  • Posts: 1,478

Re: filamaker

techbuilder2175 wrote:

If I can get 10 orders I could probably decrease the cost by an additional 50 dollars


Any takers?...Id probably be down

SD2 with E3D, SD Press, Form 1+
Filastruder
NYLON (taulman): http://www.soliforum.com/topic/466/nylon/

31 Reply by Obfuscated

  • Obfuscated
  • Member
  • Offline
  • Registered: 2013-10-28
  • Posts: 32

Re: filamaker

DePartedPrinter wrote:
techbuilder2175 wrote:

If I can get 10 orders I could probably decrease the cost by an additional 50 dollars


Any takers?...Id probably be down

Yup, I'm down for this too!!

32 Reply by techbuilder2175

  • techbuilder2175
  • techbuilder2175
  • Member
  • Offline
  • Registered: 2013-07-22
  • Posts: 338

Re: filamaker

Will move any requests to the buy and sell category.

Powder coated steel enclosure, 1/4" Surface grounded hardened aluminum plate, MK2A Heat bed, .200 Polished fused quartz plate, Machined quick change hot bed mount, E3D hot end, Ramps 1.4, DRV8825 stepper motor drivers