1 Topic by adrian (edited by adrian 2013-07-18 14:36:02)

  • adrian
  • Member
  • Offline
  • From: Canberra, Australia
  • Registered: 2013-01-15
  • Posts: 1,623

Topic: The $1 Euro Yoda's

I was curious how low can you go... and technically.. they are 'under a Euro' each wink (I'd say 80% the height, 60% the diameter)

http://farm8.staticflickr.com/7307/9315288188_c5570b75f2_b.jpg
http://farm4.staticflickr.com/3674/9315290486_10d6d53ffa_b.jpg
http://farm8.staticflickr.com/7444/9312499805_fd56f5c893_b.jpg

Thats at .152 layer... I could probably go down to .1 or .05 quite easily still, but wanted a quick print. No cleaning done as you can tell by the odd stringy bit.

Punched out all 4 yoda's in just on 35minutes ... not perfect by anymeans.. but presentable ...

2 Reply by mr_tim34

  • mr_tim34
  • Member
  • Offline
  • Registered: 2013-02-17
  • Posts: 111

Re: The $1 Euro Yoda's

But they're red.  ;-)  ~9 minutes each is pretty impressive.

TiM

3 Reply by 2n2r5

  • 2n2r5
  • 2n2r5
  • Member
  • Offline
  • From: Frederick, MD
  • Registered: 2013-05-09
  • Posts: 1,208

Re: The $1 Euro Yoda's

$1?? I'll give you a nickle each for 'em. tongue nice print!

SD3 w/ mods:
Glass bed with QU-BD heat pad upgrade, threadless ballscrew w/ 8mm smooth rod, spectra line belt replacement, lawsy MK5 extruder, Lawsy replacement carriage, E3D hotend, Ramps 1.4 w/ reprap discount controller, DRV8825 drivers, 12v 30A PS, Acrylic case, Overkill Y-idlers, Filament alarm, Extruder fan + more.

2n2r5's Website