Topic: sorceress v2
the new version of my sorceress. this time you don't need any support, and for bonus, you win a stand to put her on ( or any other figurine)
follow the link in my signature as i don't think i will use thingiverse anymore..
enjoy
1 2013-04-20 00:44:09 (edited by ysb 2013-04-20 00:53:15)
- ysb
- Member
- Offline
- frozensoda
- Member
- Offline
Re: sorceress v2
+1
I edit my posts a lot.
- Leghk
- Member
- Offline
Re: sorceress v2
These are all great looking figurines - thank you for this gift.
Donated!
Don: Folger Tech 2020 Kossel Rev A + Borosilicate + Snow Effector
Davinci 1.0 + Repetier : Filastruder
SD3 + RAMPS + Lawsy Carriages + E3D + Borosilicate + ... : Cupcake
Davinci 1.0 + Repetier : Filastruder
SD3 + RAMPS + Lawsy Carriages + E3D + Borosilicate + ... : Cupcake
- ysb
- Member
- Offline
Re: sorceress v2
'small model' are not the good words as i use all the size i can on my solidoodle.. the figurine herself is 140mm tall... if someone had a well dialed printer for 0.1mm layer... perhaps they can try to print her ar 25mm scale but it will be a tricky print... but thank you
leghk you've got an email
Re: sorceress v2
I'm actually printing this now as a proper test for some software I've tweaked for the pendpad.
I'll post a photo when done.
Re: sorceress v2
Cheers for your works ysb; I've previously printed "Who will be the first" and was going to buy the Sorceress to support your efforts but in between that you'd gone to the Donate model... so I have done so 
Also will give this bad-girl a go now as well, probably in the PLA I still have loaded...
- ysb
- Member
- Offline
Re: sorceress v2
thank you all for your support... 